Branding and Wayfinding Plan Services

The Vendor is required to provide to undertake a project aimed at supporting sign fabrication and sign installation of wayfinding family of signs that will direct people to and help them navigate the town.
- The objectives of the two-part project are as follows:
•    Sign fabrication from the master plan
•    Sign Installation on several locations
- Manufacturers recommend installation procedures which when approved will become the basis for accepting or rejecting actual installation procedures used on the project.
- Manufacturer recommended care and maintenance instructions.
- Estimated Dimensional requirements:
•    Small Vehicular Directional - 60" H x 42" W x 6" D`
•    Large Vehicular Directional - 72" H x 47.5" W x 6" D
•    Parking ID- 30" H x 36" W x .080" D
•    Parking/Directional- 18" x 12" x .080
- Division at least 48 hours before the installation of any of the signs described in this bid package.
- All finished work shall be ofthe highest quality to pass eye-level examination and scrutiny by the Town and the Designer. To accomplish this requirement, the Contractor shall do the following:
•    Construct all work to eliminate burrs, dents, cutting edges, and sharp corners.
•    Ensure that welds on exposed surfaces are imperceptible in the finished work.
•    Except as indicated or directed otherwise, finish all surfaces smooth.
•    Ensure that all surfaces which are intended to be flat are without dents, bulges, oil canning, gaps, or other physical deformities.
•    Ensure that surfaces which are intended to be curved are smoothly free-flowing to required shapes.
•    Except where approved by Designer, conceal all fasteners.
•    Follow manufacturer’s recommended fabricating procedures carefully regarding expansion/ contraction, fastening, and restraining of acrylic plastic.
•    Exercise care to assure that painted, polished, and plated surfaces are unblemished in finished work.
•    Isolate dissimilar materials, exercising special care to isolate nonferrous metals from ferrous metals.
•    Ease all exposed metal edges.
•    Wrap all digital output graphics around edges of sign panels except where approved otherwise.
•    Clear coat screened graphics to increase durability.
•    Utilize all appropriate vandal resistant and safety technologies to facilitate durability and safety of the installed signs.
- Double-Sided Signs: Unless otherwise indicated, double-sided signs will have the same content on each side of the sign, with the arrows opposite from each other so as to correctly indicate the proper direction.