The Vendor is required to provide for lenel S2 card access system:
• S2-nn-e2r-wm lenel/s2 network node in wall mount enclosure with 1 s2 ACM blade (supports up to 7 s2 application blades)
• S2-acm lenels2 access control application blade with support for 2 OSDP or WIEGAND readers, 4 inputs and 4 outputs
• Al1024ulxpd16cb ALTRONIX 24v power supply, 10 amp, w/pd16. 12v 7.5ah battery
• 40tks-00-000000 hid SIGNO profile 00 - multi-tech readers with BLE, mobile ready signo40, wall mount, 13.56mhz &125khz, OSDP/WIEGAND, terminal, mobile ready, BLE
• 20tks-00-000000 hid SIGNO profile 00 - multi-tech readers with BLE, mobile ready signo20, mullion, 13.56mhz &125khz, OSDP/WIEGAND, terminal, mobile ready, BLE
1. Universal time delay module (auto door opener bypass)
2. Ds160 BOSCH PIR request to exit sensor with sounder
3. 9400-12/ 24d-630 HES surface mount door strike
4. N1178 NASCOM recessed 1" stubby terminal switch for
Steel/wood doors with magnet, white
• Cable, WIREMOLD, conduit, boxes & ECT
• 5200c HES strike kit
• Electronic latch retraction kit for von DUPRIN
• Power transfer hinge
• Installation
• New Node & power supply near the network equipment.
• Install plywood on the wall- for the node & p/s
• All double door situations, both doors will get an electronic strike
• Customer to provide network connection & static IP address for the new node
• Electronic hardware
• Program & set up each door
• Customer to provide an admin login to be able to add/program doors
• All cabling is low voltage
• Provide/install any conduit/wire mold needed. Power for electronic hardware is also low voltage & will come from the access system power supplies.
• All doors will come with electrified hardware (Hinges, strikes, position switches, auto operators, power supplies) highlighted in attached specifications – except the card readers and system controllers.
• Card readers are listed as by electrician, but will come from the vendor.
• Hardware group numbers are listed in the door schedule.